|
GB Brand-new on the market: USB-AVR-starterboard GB myAVR assembly kit 2 USB PLUS with LCD with ATMEL microcontroller ATmega8 inclusive USB Programmer and high-quality LCD kit – LCD with background lighting! inclusive CD with software, info material and example programs Attention: You have to assemble the board by yourself. * inclusive USB Programmer, attachable! By other solutions this must be acquired additionally! * inclusive low power microcontroller * minimum (fair) forwarding expenses * with invoice and Email-support (english) * software myAVR Quickprog and myAVR Workpad SE demo free of charge, downloadable * suitable particularly as training system * and LCD-Board as assembly kit! with contrast regulator and programmable brightness control Our products fulfill the European Union guidelines prescribed legally for the sales and enterprise. The appropriate test reports and EMV labor protocols are available from us. The product carries the CE marking, the conformity explanation can be seen. * printed circuit board myAVR board version 2 (unequipped, pre-drilled, tin-plated, industrial quality), with intelligent USB-Programmer and –interface microcontroller Atmega8L 8PI voltage regulator 6V, 7806 potentiometer 47 kOhm with shaft pin header 20 way, female, straight pin header 20 way, female, right angle pin header 10 way, female, right angle * enclosed: assembly instruction, circuit diagram, layout diagram and myAVR Resource CD * LCD-kit: board, LCD 2 lines to 16 signs with backlight, female header, plug strip, potentiometer (for contrast), resistor, transistor (brightness control over PWM), jumper * The USB-Programmer can be also used individually: * to program other AVR systems over an ISP connection * to realise of an USB parallel interface * to realise of an USB serial interface (UART = COM = RS 232) The USB-Programmer can be updated over a bootloader, e.g. to support new processors or instructions. Microcontroller AVR ATmega8: * Hi-Performance Low-Power advanced RISC-Architecture * 8KBytes of In-System Self-Programmable Flash (Endurance: 10.000 Write/Erase Cycles) * 512 Bytes EEPROM (Endurance: 100.000 Write/Erase Cycles) * 6x analog-digital-transformer channels * 23 Programmable I/O Lines The board extends these properties at: * serial interface (RS232) about USB!!! * 2 miniature switch for digital input * 2 potentiometer for analog input * 3 LEDs (red, yellow, green) for digital output * piezo electric buzzer for analog output * interface for extension boards * USB-Programmer with AVR910 more compatible firmware and bootloader Designed after didactic principles -> especially suitably for beginners! Software and documents on CD and still more available on the Internet: Saxony (Germany) with Post Modern New commodity with warranty VAT is shown on the invoice At delivery outside the European Union you will receive a net invoice. In this case the price is less 19% VAT plus postage. Please ask if necessary. One month right of withdrawal Laser & Co. Solutions GmbH Promenadenring 8, 02708 Löbau manager: Alexander Huwaldt local court Dresden, HRB 4228 Starterkit, Starter-Kit, PIC, 8051, µC,MCU Mikrocontroller,LCD, Microcontrollern, Microcontroller, Lernen, Lernset, Einsteigerset, Einsteiger-Set, Einstieg, USB, USB-Programmer, learning, learning-set, access, apprendre, apprentissage, apprender, Mikrokontroller, USB Programmer, Microcontrollore, µ, Atmel, myAVR, AVR (all content is the responsibility of the poster) |
J-hopkins@oklahomaselltoday.com (Jessica Hopkins) for more information. All emails will be forwarded to the poster's actual email address.