|
SUMITOMO TYPE 35 SE FUSION SPLICER TYPE-35SE * THE SPLICER IS IN USED CONDITION * Automatic splice loss estimation for single mode and multimode fiber * High resolution LCD screen displays fibers before, during and after splicing * Advanced software monitors electrodes and compensates for wear * Simple, accessible controls * Programmable high speed heater shrinks sleeve around splice joint in 90 seconds or less * Microprocessor-controlled self-test, calibration and diagnostics * 100 splice memory stores date and time stamped loss estimates No. of fusion condition settings 3 fiber profiles with 7 programs each Parameters 5 parameters for each program Fiber alignment core (sm) or cladding (sm and mm) Fiber diameter similar or dissimilar Display message language selectable Type single mode or multi mode Fiber coating diameter 1.5 mm maximum Cleave length 16 mm, 12 mm (4 mm, 9 mm optional) Core size 4-to-14 µm single mode, 50/125 µm, 62.5/125 µm, Typical splice loss 0.03 dB (when using homogeneous SM fiber) 0.02 dB (when using homogeneous SM fiber) Typical splice cycle time 45 seconds ("set"-to-loss estimate) Data memory 100 estimated splice loss measurements Battery life (BU-03SE) 60 splices per full charge (includes heat cycle) Battery charging time (BC-03SE) 8 hours for 1 battery, 14 hours for 2 batteries Data communications D-sub 9 pin jack (RS232C) 12 VDC input terminal for remote power source (BU-05SE) 12 VDC output terminal for SPL-1 Video output BNC type jack (for NTSC video signal) Input 85-265 VAC (50-60 Hz, 34 W), 11-145 VDC (29W) Operation temperature 14°F to 122°F (-10°C to 50°C) Operation humidity 95% RH non-condensing LCD monitor size 3 inches diagonal For Questions, Quantity pricing, and Offers please Email to Certain images/photos are the copyrighted property of JupiterImages and are used with permission under license. (all content is the responsibility of the poster) |