|
For sale are Advanced Motion Controls (AMC) brush type servo amplifiers. 30A8 Full Datasheet can be viewed at: http:// /download/datasheet/30a8.pdf · Small size, low cost, ease of use · DIP switch selectable: current, voltage, velocity, analog position loop · Four quadrant regenerative operation The 50A Series PWM servo amplifiers are designed to drive brush type DC motors. A single red/green LED indicates operating status. All models are fully protected against over-voltage, over-current, over-heating and shortcircuits across motor, ground and power leads. All models interface with digital controllers or can be used as a standalone drive. They require only a single unregulated DC power supply. Loop gain, current limit, input gain and offset can be adjusted using 14-turn potentiometers. The offset adjusting potentiometer can also be used as an on-board input signal for testing purposes when SW10 (DIP switch) is ON. POWER STAGE SPECIFICATIONS 30A8 PEAK CURRENT (2 sec. maximum) ± 30 A MAXIMUM CONTINUOUS CURRENT ± 15 A MINIMUM LOAD INDUCTANCE* 200 μH HEATSINK (BASE) TEMPERATURE RANGE 0° to + 65° C, disables if > 65° C POWER DISSIPATION AT CONTINUOUS CURRENT 60 W OVER-VOLTAGE SHUT-DOWN (self reset) 86 V BANDWIDTH (load dependent) 2.5 kHz (all content is the responsibility of the poster) |
m-james@oklahomaselltoday.com (Misty James) for more information. All emails will be forwarded to the poster's actual email address.