|
Introducing our new USB AVR JTAG Debugger & Programmer ! Program and debug your Atmel AVR Microcontroller project with our great new JTAG interface. This unit plugs directly into the target board for controlling and programming your AVR device. Works with AVR Studio IDE and allows for single stepping through your program, viewing register values and also for programming the microcontroller. Find program errors quickly and easily, with this easy to use debugging tool. Programs can be downloaded directly through the JTAG interface to your target board. Program execution can be initiated from the program and the various register values read and monitored through the software. Easily find program errors and control program execution through the easy to use, user interface. This USB AVR JTAG connects directly to your computers or laptops USB port. A 10 pin connector then connects to the target board. It is powered from the USB port and no separate power supply is required. • Dramatically Reduce Program Development and Testing Time • Single Step Through your Program and Monitor Register Values • Set Breakpoints and Watch Values • Works with Atmel AVR Studio Software • No Separate Power Supply Required Uses On-Board Supply • ATMega16x: ATMega16, ATMega16L, ATMega162, ATMega162L, ATMega169, ATMega169L, ATMega169V • ATMega32x: ATMega32, ATMega32L, ATMega323, ATMega323L • ATMega64: ATMega64, ATMega64L • ATMega128: ATMega128, ATMega128L The onboard firmware is upgradeable via AVRStudio IDE to support newly introduced devices. 1. One USB AVR JTAG Debugger & Programmer ; 3. One 10-pin JTAG interface cable; 4. One USB driver/Software CD. this USB AVR JTAGICE-II package is posted... - You will get it within a few days - (all content is the responsibility of the poster) |
Karin_Molina@oklahomaselltoday.com (Karin Molina) for more information. All emails will be forwarded to the poster's actual email address.