2.25HP 260 VDC Permanent Magnet motor Pulley/Fan not included with motor (see my store to purchase pulley/fan) International S & H subject to change up to sale of item * Rotation reversible *(see paragraph above) * Duty int. w/o cooling fan (not incl.) * Mount 2 threaded holes in side of body * Shaft 17 mm dia x 15/16" w/ 1/2"-13 x 7/8" long UNC LH threaded end * Size 7 3/4" x 4" x 4" excluding face plate This motor can run both directions.. The rated voltage of the motor is 260 VDC for 5100 RPM operation. Lower voltages can be used and the RPM will be reduced proportionally. See the chart below: The motor does not come with a 6" dia pulley/fan with 1-3/8" dia. 6 groove poly V pulley. Purchase pulley at my store if you need it. A belt can be added to the pulley to facilitate turning the motor. Turning the motor will produce a voltage at the terminal wires. So mechanical rotation on the motor shaft creates power in form of voltage at the motor terminals. For this DC motor the back EMF is about 35 mV/RPM The following is a picture of the motor shown with optional pully/fan: The motor diameter is about 3.1 inches. The motor housing is about 7 3/4 inches long and the shaft is about 1 7/8 inches long. The shaft end is 1/2" threaded shaft on a 5/8" shaft, see the following picture (pulley not included, see store to purchase): The motor has two mounting holes on the bottom: (all content is the responsibility of the poster) |
n_townsend@oklahomaselltoday.com (Natalia Townsend)
for more information. All emails will be forwarded to the poster's actual email address.