|
Lansing Instruments MicroPak type Q Enclosure. Your home built electronics project will look great in this professional style all metal enclosure from Lansing. These are new leftover's from a run of surround sound decoders. The front is punched for 3 pots and two LED's. The rear is punched for 5 phono jacks and a power connector. You can easily cut new unpunched panel ends from aluminum stock or phenolic board. The plastic bezels surround the end panels. The thick aluminum bottom has a slide in mount system for a printed circuit board 5" long by 3-7/8" wide. The case top is ferrous metal for shielding and slides over the base so no screws show. There are rubber feet on the bottom. O.E.M. cost was $16.55 each. Made in the USA. Very strong construction. Color is gray. Exact outside dimensions are 4.17" wide. 1.52" high. 5.25" deep. The surround sound decoder circuit boards and an assortment of passive components ( resistors, capacitors, pots, ) from the original device will be included with each box, but sorry, no information about the circuit is included. Construction article was published in Electronics Now magazine. (all content is the responsibility of the poster) |
d_boyd@oklahomaselltoday.com (Dixie Boyd) for more information. All emails will be forwarded to the poster's actual email address.